LT2 Bino Harness Specs and Sizing | Lone Trail
Specifications
LT2 Bino Harness: every number, before you buy
No marketing adjectives in this section. Here is what it is made of, what fits in it, and what happens if it fails.
$75LT2 Bino Harness
Full specification
| Fabric | 500D Cordura shell covered in StealthStalk |
| Bino compartment | 6" wide x 7.1" tall |
| Fits optics | 8x32 through 10x42, and most 12x50 |
| Closure | Upgraded quiet magnets, one-handed |
| MOLLE | Bottom and both sides |
| Extra storage | Front pouch, interior pocket, extra side pocket |
| Fit range | Roughly 80 to 400 lb, quick-adjust buckles |
| Warranty | Lifetime against manufacturing defects |
Lifetime warrantySeam, buckle, magnet or zipper fails from how it was made, we replace it.
30 days, free returnsOn unused gear. If it does not fit your optics, send it back.
Free shipping over $20Most orders ship free.
What each spec means in the field
Fabric noise
StealthStalk over 500D Cordura, built specifically to stay quiet against brush in cold, dry conditions.
Closure noise
Upgraded quiet magnets. One hand, no zipper buzz, no Velcro.
Storage
A front pouch, an interior pocket and an extra side pocket on top of the main compartment.
Accessory mounting
MOLLE on the bottom and both sides, so a rangefinder pouch or bear spray holster rides where your hand goes.
The short version
- StealthStalk fabric dampens the noise a harness makes against brush. In cold, dry air where a lot of harnesses crinkle, the LT2 stays quiet.
- Upgraded magnets open with one hand and hold your glass secure while you climb or crawl.
- Three more pockets than the LT1: a front pouch, an interior pocket, and an extra side pocket.
- Quick-adjust buckles resize the harness in the field in seconds, over a light layer or a heavy jacket.
LT2 Bino Harness, $75
Lifetime warranty against manufacturing defects, and 30 days of free returns if it is not right for your setup.